Dedicated in Solids Control Since 1987 sales@trsolidscontrol.com +86-13186019379 中文

Drilling Cutting System

ProductId:Drilling Cutting Managment System

Drilling cuttings management system is a kind of Mud Solids Control system.

+86-13186019379 +86-29-86332919 sales@trsolidscontrol.com
INTRODUCTION
Oil Drilling Solid Control can be refered as DWM (Drilling Waste Managemnet),it ia a highly vital part of oil&gas drilling.Solids control is a technique used for well drilling to provide prepared drilling fluids for drilling rigs. Drilling fluid maintenance cost, clean up, and disposal cost as well as the overall cost of boring can be reduced dramatically when proper solids control techniques are utilized.
TR drilling cuttings management system is used for taking drilling fluids from the drilling cuttings and clean the fluids for resuse.It is to maximize the recycling of drilling fluids,and minimize the drilling waste in order to save cost for operators.There are two ways to recovery drilling cuttings,but their purpose is the same.


BENEFITS
1.For oil based drilling cuttings, normally it can reduce the oil on the cuttings to 3% to 5%.
2.For water based drilling cuttings, normally it can reduce the moisture content for easy transportation.
3.Recycling drilling fluids for reuse to save cost.

SPECIFICATION

S/N

S/N

Description

1

Vertical Cuttings Dryer

TRCD930 with option for VFD or fixed speed

2

Decanter Centrifuge

TRGLW355Centrifuge 14inch bowl,Optional model as below:
TRGLW355 Centrifuge with VFD drive.
TRGLW355 standard with fixed speed  

3

Screw Pump

Two sets TRG30A-075 Screw Pump with capacity:30m³/h for each pump.
One for taking fluids from catching tank to feed the decanter centrifuge,the other for flushing the Vertical dryer.

4

Skid with catching tank

Fast move skid for mounting all the equipment
One Catching tank with capacity:4m³ for catching fluid from vertical cuttings dryer.

5

Telescopic Skid

Two telescopic skid with walkways and handrails for safe operation.
One for mounting the decanter centrifuge to a higher position in order to allow the centrifuge discharged fluids feed to active mud system by gravity.
The other telescopic skid for mounting and adjusting the height of the vertical cutting dryer to allow the discharge of drying cuttings

6

Electric Cradle

0.5 Tons electric cradle for lifting the components of vertical dryer

7

Electric Control System

Two lighting system,electrical control boxes and cables and plugs for operation the complete system.


GALLERY
Drilling Cuttings Management systemdrilling cutting managment system

TR WeChat

Company:TR Solids Control

Add:10 West The North Second Ring WeiYang,Xi'an,China

Factory Address: No.68 Caotang Industry Zone Huxian County Xi'an City 

Call:13186019379

E-mail:sales@trsolidscontrol.com

Web:www.chinasolidscontrol.com

© 2016 TR Solids Control Corporation. All rights reserved. TR Solids Control and its products indicated by trademark symbols are trademarks and/or registered trademarks of TR Solids Control Corporation.

Contact Us

TEL:+86-29-86332919

CALL:+86-13186019379

SKYPE

Skype:

Skype:

What’s App

  • 13186019379
  • 18509252400

Contact Us

TEL:+86-29-86332919

CALL:+86-13186019379

SKYPE

Skype:

Skype:

What’s App

13186019379

18509252400